Information on ingredients

Apply Method

I. Clean the mold with two alternative methods after removing the workpiece.

1. For cleaning a general mold chasis: prepare a mixture of 50% RBS-35 and 50% clean water, heat it to 80-90¢XC and soak the mold chasis in the solution for 1-2 hours. The mold chasis will return to its brand new state again. In case of stubborn stains, prolong the soaking to 4-8 hours. After soaking, rinse the mold with clean water and dry it with oven.
2. Using an ultrasonic cleaning machine may shorten the cleaning time as well as to allow an effective cleaning at a low concentration of the solution. Increasing the concentration or temperature of the mold cleaning solution may also expedite the cleaning process. However, when using a high-temperature cleaning solution, the workpiece must be washed with water immediately after removing from the solution.

II. When the mold is on the packaging machine

1. Dilute the solution to a concentration of 2% (volume), this shall be adequate for the work.
2. If possible, lower the mold temperature to 80-100¢XC for a better effect.
3. Apply the cleaning solution to the lower part of the mold with a nylon brush or cotton cloth, followed by closing the mold for 3-5 minutes, allowing the vapor of the RBS-35 to reach the upper part of the mold.
4. Separate the mold; blow off softened stain from the mold surface using a jet of compressed air. Further clean the mold with a nylon brush if necessary.
5. After that, clean the mold with CLEAN COMPOND, a mold cleaning jelly, so as to completely clean the mold.
 

Physical and chemical properties

Physical state :Liquid
Colour :White (Milk-like).
Odour :Negligible
Ph value :¡Ó13.2
Density :1.07
Solubility in water :Complete
Flash point [℃] :Not applicable